Changing units from mm to inch on details
Moderators: remi77, Daniel, jacs
Changing units from mm to inch on details
I have just started to use the electrode package for Top Solid, and for some reason I can not change the units from mm to inch in the Electrode Draft part of this program. I have went in and changed the units under Units, and I have also changed them under Dimension but still no change to the X,Y,Z locations. Is there a way to set the default for this section to inch before I even strart detailing.
-
- Private
- Posts: 3
- Joined: Wed Oct 28, 2015 6:47 pm
- TopSolid Module: TopSolid'Design
- TopSolid Version: 6.18
Re: Changing units from mm to inch on details
I am having a similar problem. I have changed the document units from mm to inches (Options-->Units), and as a result the basic length dimensions are in inches
. However, the diameters in the drilling notes are still in mm
(see below).
My office just upgraded from TS7.8 to TS7.10, and I know how to fix it in 7.8. The drilling note command windows used to let me define the units for a specific instance of a note, but the new command windows don't have that feature.
I have also tried Tools-->Options-->General-->Units, and I don't see File-->Properties as jalapeno suggests. Any suggestions for changing the dimension settings for drilling notes?


My office just upgraded from TS7.8 to TS7.10, and I know how to fix it in 7.8. The drilling note command windows used to let me define the units for a specific instance of a note, but the new command windows don't have that feature.
I have also tried Tools-->Options-->General-->Units, and I don't see File-->Properties as jalapeno suggests. Any suggestions for changing the dimension settings for drilling notes?