TSW "Distance" command output

Integrated solution for design, manufacturing and management that provides all standard parts and procedures for wood processing.

Moderators: remi77, jacs, Daniel

User avatar
OMG
Master Chief
Master Chief
Posts: 112
Joined: Sun Nov 11, 2018 7:26 pm
Answers: 3
TopSolid Module: TopSolid'Wood
TopSolid Version: 6.20

TSW "Distance" command output

Unread post by OMG »

Hello

Is there a way to configure TSW to display in Alpha bar not only the simple distance between two 3D points but the X, Y and Z components too (the ones you see in 3D area)?

Thank you
02.JPG
02.JPG (8.36 KiB) Viewed 1734 times
01.JPG
User avatar
olaio
Second Officer Cadet
Second Officer Cadet
Posts: 194
Joined: Thu Mar 01, 2007 11:42 am
Answers: 2
Location: Leiria

Re: TSW "Distance" command output

Unread post by olaio »

Hello,

you need to have at least two lines on your alpha bar:
Alpha.png
Alpha.png (3.35 KiB) Viewed 1710 times
Best regards
User avatar
OMG
Master Chief
Master Chief
Posts: 112
Joined: Sun Nov 11, 2018 7:26 pm
Answers: 3
TopSolid Module: TopSolid'Wood
TopSolid Version: 6.20

Re: TSW "Distance" command output

Unread post by OMG »

Hello

My alpha bar is always detached and shown because I use two monitors.
I still don't manage to obtain the measurement as you did.
I tried to switch between "value" and "element" in "status bar configuration / measurement" but without any luck

01.PNG
02.PNG
RaudMees
Second Officer Cadet
Second Officer Cadet
Posts: 209
Joined: Wed Dec 30, 2015 11:25 am
Answers: 3
TopSolid Module: TopSolid'Wood
TopSolid Version: 6.20
Contact:

Re: TSW "Distance" command output

Unread post by RaudMees »

Maybe You have to change some settings.
I have this.
Attachments
dist.png
dist.png (5.02 KiB) Viewed 1635 times
User avatar
Laurens
Sergeant
Sergeant
Posts: 50
Joined: Tue Apr 16, 2019 7:29 am
Answers: 5
TopSolid Module: TopSolid'Wood
TopSolid Version: 6.24

Re: TSW "Distance" command output

Unread post by Laurens »

i get both results RaudMees. if i measure from point to point i get what you have. if i choose plane->point then i get what OMG has. so far i have yet to find a setting for this
Laurens

Team leader TSW draftsmen
De Klerk Binnenbouw
Post Reply