Hello, I have made a video of a feature which I feel would be a huge benefit to TopSolid users. Note that we can easily check the radius and angle of any face even if it has a varied radius or varied angle.
In my opinion this should enhance the analyze category of all TopSolid modules.
This link should take you to the video clip.
ugh... bad link... see below.
Thoughts ?
Analyze Dynamic enhancement request
Moderators: remi77, jacs, Daniel
- Matt Berube
- Master Corporal
- Posts: 45
- Joined: Wed Feb 21, 2007 7:08 pm
- Location: Connecticut, USA
Analyze Dynamic enhancement request
Last edited by Matt Berube on Fri Jan 04, 2008 3:49 pm, edited 1 time in total.
TopSolid 2006, Design 6.7.302, Cam 6.7.302, Mold 6.7.302
Mastercam X2, Mill3, Wire, Solids, Moldplus, Beta Tester
Mastercam X2, Mill3, Wire, Solids, Moldplus, Beta Tester
- Matt Berube
- Master Corporal
- Posts: 45
- Joined: Wed Feb 21, 2007 7:08 pm
- Location: Connecticut, USA
I just had somebody point out that the above link was bad.
I will attach the file directly...
Watch in fullscreen mode for clearer picture.
I will attach the file directly...
Watch in fullscreen mode for clearer picture.
- Attachments
-
- clip0008.zip
- (885.11 KiB) Downloaded 482 times
TopSolid 2006, Design 6.7.302, Cam 6.7.302, Mold 6.7.302
Mastercam X2, Mill3, Wire, Solids, Moldplus, Beta Tester
Mastercam X2, Mill3, Wire, Solids, Moldplus, Beta Tester