Multiple programs, Single CAM document

Everything about new TopSolid'Cam 7 software.

Moderators: remi77, Daniel, Bill

Posts: 20
Joined: Fri Jun 24, 2016 1:37 pm
TopSolid Module: TopSolid'Cam
TopSolid Version: 7.9
Location: Huntsville, AL

Multiple programs, Single CAM document

Unread post by Billetgrip »

How do you guys generate code for multiple programs in a single CAM document?

I programmed my part but the code was too long to fit in the machine. I managed to break it up into 6 programs but it won't generate code. I keep getting "Last link out is not to CTP" and "First link in is not from CTP" errors even after rebuilding.
Post Reply