Hello,
I installed the below options for TopSolid as shown in the first picture below. I do not use DME Inch, Futaba, Hasco, Meusburger etc tooling.
Could someone please tell me how do I go and unistal these? Should I re-run the setup.exe file or should I just add/remove programs as shown in the second picture below?
Picture 1:
.
PICTURE 2:
..
Thanks in advance,
Michelle
Best way to uninstall redundant tooling libraries
Moderators: remi77, jacs, Daniel
Best way to uninstall redundant tooling libraries
Last edited by michelle on Mon Sep 04, 2017 3:44 pm, edited 1 time in total.
Re: Best way to uninstall redundant tooling libraries
Hi Michelle
Try to launch the installation program (choose) REPAIR) and uncheck the options you want to discard.
Following this, you may check the obsolete programs, libraries in the windows uninstaller
See you
Rémi
Try to launch the installation program (choose) REPAIR) and uncheck the options you want to discard.
Following this, you may check the obsolete programs, libraries in the windows uninstaller
See you
Rémi
Thanks to use the on the best answer when you've got the solution.
Re: Best way to uninstall redundant tooling libraries
Hi Remi,
Thank-you for your quick reply. I am busy following your instructions however just before I go and uninstall TopSolid'Tooling I would like to check my understanding if you would not mind:
Q1) Are all the yellow highlighted Libraries below 3rd party Tooling libraries, so if I don't use these tools, I don't need to install them?
Q2) What is TopSolid'Strip Design and when would you use it?
Q3) What is TopSolid Progressive Tooling and when would you use it?
Q2) What is TopSolid'Split?
Answer: This chapter introduces you to the “TopSolid’Split” module. This module allows you to create core and cavity block splits, and also sub-inserts without any consideration to the final use of these blocks (See TopSolid Design Guide page 282).
.
. .
.
Thanks again for your patience,
Michelle
Thank-you for your quick reply. I am busy following your instructions however just before I go and uninstall TopSolid'Tooling I would like to check my understanding if you would not mind:
Q1) Are all the yellow highlighted Libraries below 3rd party Tooling libraries, so if I don't use these tools, I don't need to install them?
Q2) What is TopSolid'Strip Design and when would you use it?
Q3) What is TopSolid Progressive Tooling and when would you use it?
Q2) What is TopSolid'Split?
Answer: This chapter introduces you to the “TopSolid’Split” module. This module allows you to create core and cavity block splits, and also sub-inserts without any consideration to the final use of these blocks (See TopSolid Design Guide page 282).
.
. .
.
Thanks again for your patience,
Michelle
Re: Best way to uninstall redundant tooling libraries
Hello
See you
Rémi
No you needn'tQ1) Are all the yellow highlighted Libraries below 3rd party Tooling libraries, so if I don't use these tools, I don't need to install them?
Strip design is related to progressive tooling.What is TopSolid'Strip Design and when would you use it?
It's designed for stamping toolsWhat is TopSolid Progressive Tooling and when would you use it?
See you
Rémi
Thanks to use the on the best answer when you've got the solution.
Re: Best way to uninstall redundant tooling libraries
Solved - Thank-you Remi!
Re: Best way to uninstall redundant tooling libraries
Hi
It's oaky
Always glad to help
See you
Rémi
It's oaky
Always glad to help
See you
Rémi
Thanks to use the on the best answer when you've got the solution.