I want to have a table of holes and tapped holes and dowel holes... The dowel holes need to show as 4 place decimal.. I have not been able to figure out how to do this in one Drilling table
So I thought I would create a separate Dowel drilling table, but the numbering starts at 1 again for the second table.... Is there a way to change to letter indexes ???
Use letters for drilling table Indexes
Moderators: remi77, jacs, Daniel, Bill, Romain
- JuP
- Major
- Posts: 169
- Joined: Tue Sep 09, 2014 5:45 pm
- TopSolid Module: TopSolid'Steel
- TopSolid Version: 7.14
Re: Use letters for drilling table Indexes
Hello,
You have to use styles (entities tree) to change the number of decimals, if you are creating the drilling table: If the table is already created create a new style and apply it (right click and Apply):
You have to use styles (entities tree) to change the number of decimals, if you are creating the drilling table: If the table is already created create a new style and apply it (right click and Apply):
-
- Master Corporal
- Posts: 32
- Joined: Wed May 05, 2010 1:24 am
- TopSolid Module: TopSolid'Design
- TopSolid Version: 6.26
- Location: Upstate New York (Buffalo)
Re: Use letters for drilling table Indexes
JuP,
Thanks for the reply, but what you describe is not what I am talking about.
I am talking about having letters instead of numbers for the indexes for a hole table...
Thanks for the reply, but what you describe is not what I am talking about.
I am talking about having letters instead of numbers for the indexes for a hole table...