Everything about new TopSolid'Cam 7 software.
Moderators: remi77, Daniel, Bill
-
cam
- Master Corporal
- Posts: 39
- Joined: Fri Oct 02, 2009 9:46 am
- TopSolid Module: TopSolid'Cam
- TopSolid Version: 7.8
- Location: Germany
Unread post
by cam »
Is it possible to do trochodial milling in TS CAM V7.6 ??
And how does it work ?
Last edited by
cam on Fri Jun 24, 2016 2:11 pm, edited 1 time in total.
-
YannDODIN
- Private
- Posts: 1
- Joined: Wed Jan 25, 2012 4:35 pm
Unread post
by YannDODIN »
Yes you can do trochoidal milling. You can do it in grooving (you create a line and use the grooving operation then selct the trochoidal).
I have tried a few times and it is ok!
-
cam
- Master Corporal
- Posts: 39
- Joined: Fri Oct 02, 2009 9:46 am
- TopSolid Module: TopSolid'Cam
- TopSolid Version: 7.8
- Location: Germany
Unread post
by cam »
Thankyou, it works well...
-
remi77
- Administator
- Posts: 348
- Joined: Thu Feb 22, 2007 10:05 am
-
Contact:
Unread post
by remi77 »
cam wrote:Is it possible to do trochodial milling in TS CAM V7.6 ??
And how does it work ?
-
Bill
- Master Chief
- Posts: 115
- Joined: Wed Feb 21, 2007 8:17 pm
- TopSolid Module: TopSolid'Design
- TopSolid Version: 6.25
- Location: Chicago
-
Contact:
Unread post
by Bill »
You can do it in any tool path that is a roughing tool path. End milling, slot milling, roughing...
Happy Designing
Bill
Technical Director
Missler Software Inc