Hi everybody,
i have an stl file (capacity 17MB) that i can open it with other SWs like Geomagic, Leios, Zprint, Solidworks, but i can't open it with my TopSolid (v6 and v7). It has almost 500K triangles. Is it possible to open it?
Do i have to put something in my top.cfg file, in order to open big stl files?
Thanks
[Solved] Opening STL files
Moderators: remi77, jacs, Daniel
[Solved] Opening STL files
There are no problems ... only challenges!
Hello,
None,
You may have to wait a bit, it always takes a bit of time to load STL files,
See you,
Rémi
None,
You may have to wait a bit, it always takes a bit of time to load STL files,
See you,
Rémi
Last edited by remi77 on Thu May 19, 2011 11:05 am, edited 1 time in total.
Hi,
The opening of STL file in TopSolid'Design is very long, and maybe your PC is not correctly configured (you absolutely for big STL file to use a x64 OS and software system).
I strongly recommend you, if it is possible for you, to open it with TopSolid'Cam (the interface is not the same than the Design). It is really faster than TopSolid'Design.
jehronimo
The opening of STL file in TopSolid'Design is very long, and maybe your PC is not correctly configured (you absolutely for big STL file to use a x64 OS and software system).
I strongly recommend you, if it is possible for you, to open it with TopSolid'Cam (the interface is not the same than the Design). It is really faster than TopSolid'Design.
jehronimo