Hello,
I have a TS7 assembly document with some cavity blocks and an electrode. How can I create a draft document with some specific entities from the assembly ? I want my draft to include the lower cavity block and the blue electrode. I can't figure out how to choose which entities are shown in the draft. So far it seems I can have all or nothing.
Any help would be appreciated. Thanks.
TS7 drafting help
Moderators: remi77, jacs, Daniel, Bill, Romain
Thanks Olaio !
I still do not have a clear understanding of the whole situation but I was able to get better results using your advice.
I'll have to keep playing with this as time permits. After I get just a little better I'll be using the new version for all of my electrodes and the associated documentation.
I still do not have a clear understanding of the whole situation but I was able to get better results using your advice.
I'll have to keep playing with this as time permits. After I get just a little better I'll be using the new version for all of my electrodes and the associated documentation.