Triming a Draft view

Drawing, bill of material, 2D design, dimensioning, labeling, tolerances, symbols, title blocks...

Moderators: remi77, jacs, Daniel

travis c
Private
Private
Posts: 5
Joined: Thu Oct 30, 2008 9:30 pm
Location: Kansas City, MO

Triming a Draft view

Unread post by travis c »

Is there a way to trim down a draft view. In a case were a guide line is over hanging your assembly and you dont want to show the hole line or component.
Top'Noob
First Officer Cadet
First Officer Cadet
Posts: 245
Joined: Fri Jun 15, 2007 3:05 pm

Unread post by Top'Noob »

Hello,

I think you can do this with "interrupted view"
travis c
Private
Private
Posts: 5
Joined: Thu Oct 30, 2008 9:30 pm
Location: Kansas City, MO

Unread post by travis c »

That is along the lines of what i want but I just want to trim the view down to show only what i want it to show.
User avatar
olaio
Second Officer Cadet
Second Officer Cadet
Posts: 194
Joined: Thu Mar 01, 2007 11:42 am
Answers: 2
Location: Leiria

Unread post by olaio »

Hi,

Sorry, I am not understanding your question :oops:
It looks that the solution from Top'Noob is the one.
Can you please post an image of what you need?

Cumprimentos,
Olaio
jeff
Sergeant
Sergeant
Posts: 63
Joined: Fri Feb 23, 2007 6:15 pm
Contact:

Unread post by jeff »

Travis welcome to the forum, an image of what you want to trim would be helpful, there are tools to filter out different parts of a draft view when you create the view(exceptions) and there are ways to create different sets to project, along with a host of tools to create different sections, post up an image and i am sure we will find a good solution for you
travis c
Private
Private
Posts: 5
Joined: Thu Oct 30, 2008 9:30 pm
Location: Kansas City, MO

Unread post by travis c »

Jeff,
Friday when i see you. I will show you and the repost to say if it was solved or not. If i get time before I get out of the office i will post a pic.
[/img]
travis c
Private
Private
Posts: 5
Joined: Thu Oct 30, 2008 9:30 pm
Location: Kansas City, MO

Unread post by travis c »

they way i thought it would be cant be done. the way i want to trim down a view i you have a huge assembly and you only want to show one part. I have found many different was to do it but the all take time.
User avatar
olaio
Second Officer Cadet
Second Officer Cadet
Posts: 194
Joined: Thu Mar 01, 2007 11:42 am
Answers: 2
Location: Leiria

Unread post by olaio »

Hi Travis,

Can you please send a pictures of your needs?

Cumprimentos,
Olaio
Post Reply