Is there a way to trim down a draft view. In a case were a guide line is over hanging your assembly and you dont want to show the hole line or component.
Travis welcome to the forum, an image of what you want to trim would be helpful, there are tools to filter out different parts of a draft view when you create the view(exceptions) and there are ways to create different sets to project, along with a host of tools to create different sections, post up an image and i am sure we will find a good solution for you
Jeff,
Friday when i see you. I will show you and the repost to say if it was solved or not. If i get time before I get out of the office i will post a pic.
[/img]
they way i thought it would be cant be done. the way i want to trim down a view i you have a huge assembly and you only want to show one part. I have found many different was to do it but the all take time.