Page 1 of 1

Triming a Draft view

Posted: Mon Nov 03, 2008 6:19 pm
by travis c
Is there a way to trim down a draft view. In a case were a guide line is over hanging your assembly and you dont want to show the hole line or component.

Posted: Tue Nov 04, 2008 1:18 am
by Top'Noob

I think you can do this with "interrupted view"

Posted: Tue Nov 04, 2008 4:02 pm
by travis c
That is along the lines of what i want but I just want to trim the view down to show only what i want it to show.

Posted: Tue Nov 04, 2008 4:13 pm
by olaio

Sorry, I am not understanding your question :oops:
It looks that the solution from Top'Noob is the one.
Can you please post an image of what you need?


Posted: Tue Nov 04, 2008 4:26 pm
by jeff
Travis welcome to the forum, an image of what you want to trim would be helpful, there are tools to filter out different parts of a draft view when you create the view(exceptions) and there are ways to create different sets to project, along with a host of tools to create different sections, post up an image and i am sure we will find a good solution for you

Posted: Tue Nov 04, 2008 7:46 pm
by travis c
Friday when i see you. I will show you and the repost to say if it was solved or not. If i get time before I get out of the office i will post a pic.

Posted: Wed Jan 14, 2009 4:53 pm
by travis c
they way i thought it would be cant be done. the way i want to trim down a view i you have a huge assembly and you only want to show one part. I have found many different was to do it but the all take time.

Posted: Wed Jan 14, 2009 6:33 pm
by olaio
Hi Travis,

Can you please send a pictures of your needs?