[Solved] INVALID FONT

JB · Unread post by JB » Fri Jun 20, 2008 3:04 pm

i just loaded 2008 version and went directly into 2d drawing document
loaded a part file to detail.
when i tryed to dimension it gave me INVAILD FONT warning
i then tryed to dimension in the actual part file (top) and it works fine.
has anyone ever experienced this and if so how do you fix it.
thanks brad

jehronimo · Unread post by **jehronimo** » Mon Jun 23, 2008 9:43 am

Hi,

you need to install again the ISONORM_D font from TopSolid (you can do it form the Control panel Add/remove program, with the TopSolid modification tool). I guess your actual configuration is is set to @arial_batang...