[Solved] INVALID FONT

Drawing, bill of material, 2D design, dimensioning, labeling, tolerances, symbols, title blocks...

Moderators: remi77, Daniel, jacs

JB
Private
Private
Posts: 4
Joined: Wed Nov 28, 2007 9:55 pm

[Solved] INVALID FONT

Unread post by JB » Fri Jun 20, 2008 3:04 pm

i just loaded 2008 version and went directly into 2d drawing document
loaded a part file to detail.
when i tryed to dimension it gave me INVAILD FONT warning
i then tryed to dimension in the actual part file (top) and it works fine.
has anyone ever experienced this and if so how do you fix it.
thanks brad :?: :?:

User avatar
jehronimo
Major
Major
Posts: 149
Joined: Thu Mar 01, 2007 1:05 pm

Unread post by jehronimo » Mon Jun 23, 2008 9:43 am

Hi,

you need to install again the ISONORM_D font from TopSolid (you can do it form the Control panel Add/remove program, with the TopSolid modification tool). I guess your actual configuration is is set to @arial_batang...

Post Reply