Page 1 of 1

Automatic BOM Index

Posted: Thu Jun 05, 2008 3:22 pm
by TopSolid2007
We would like to make Automatic Bom Indexes using the multi level option on the bill of material, but I received the following message:

Unable to make automatic index on multi level.

Is there another way?

Posted: Fri Jun 06, 2008 11:15 am
by olaio
Hi,

Maybe it is not the right way but it is a way that work.

First, you need to set the index of each part in the 3D file.
Then in your 2D drawing create another bom (flat bom). Use this second bom to make the automatic bom index.

Cumprimentos,
Olaio