Page 1 of 1

[Solved] different type of hole table

Posted: Fri Aug 03, 2007 2:31 pm
by Top'Noob

Is there an easy way to get a hole table like what is shown in this picture ?

So far I find the "drills table" gives way too much information for my needs and I don't like the way that each hole has a unique label.


regarding Drill Tables

Posted: Tue Oct 02, 2007 9:14 pm
by Bill

Today, I don't think that this is possible. The drill table function is design to give you the Type of Drilling, its diameter, depth and it's location. If you where to lable all common drillings diameters with the same name, you could not show the rest of the information that is provided. Perhaps, use the drilling dimension function. If you put in a TopSolid Drilling feature, and then make a pattern of it, the drilling dimension function will give you a note with the drilling information as well as the quantity.

have fun!