Page 1 of 1

[Solved] Problem conversion draft to dxf-file

Posted: Fri Jun 19, 2009 1:35 pm
by Truus
I am working with TopSolid Design 2009 (v6.10.212)
When I open a dxf-file in autocad, created with "save as" Autocad V6.7 dxf in TopSolid;
I got the following problem :
The contour-line of the part has a line who is thicker than the other lines.
How can I solve that problem?

Posted: Fri Jun 19, 2009 1:58 pm
by Top'Noob
I often get strange results from the TopSolid .dxf / .dwg translators.

I usually try different translator versions until the appearance is better...

P.S. Welcome to the forum :)

Posted: Wed Oct 14, 2009 10:16 am
by Truus
Thanks,
A good solution :lol:

Posted: Wed Oct 14, 2009 2:48 pm
by olaio
Hi,

In autocad you can explode the contour, then it should have the same thickness than the other lines.

Posted: Tue Oct 20, 2009 3:31 pm
by TopSolid2007
The best solution we found here was to firstly save the dft file as igs and open again this igs file and save as dxf/dwg...

The draw looks great this way, but the dimensions obviously were only texts.