Product design in 3D, mechanical engineering, kinematics, dynamics, parts and components, surfacic, assemblies...
Moderators: remi77 , jacs , Daniel
Truus
Private
Posts: 3 Joined: Fri Jun 19, 2009 1:26 pm
Unread post
by Truus » Fri Jun 19, 2009 1:35 pm
I am working with TopSolid Design 2009 (v6.10.212)
When I open a dxf-file in autocad, created with "save as" Autocad V6.7 dxf in TopSolid;
I got the following problem :
The contour-line of the part has a line who is thicker than the other lines.
How can I solve that problem?
Top'Noob
First Officer Cadet
Posts: 245 Joined: Fri Jun 15, 2007 3:05 pm
Unread post
by Top'Noob » Fri Jun 19, 2009 1:58 pm
I often get strange results from the TopSolid .dxf / .dwg translators.
I usually try different translator versions until the appearance is better...
P.S. Welcome to the forum
Truus
Private
Posts: 3 Joined: Fri Jun 19, 2009 1:26 pm
Unread post
by Truus » Wed Oct 14, 2009 10:16 am
Thanks,
A good solution
olaio
Second Officer Cadet
Posts: 194 Joined: Thu Mar 01, 2007 11:42 am
Answers: 2
Location: Leiria
Unread post
by olaio » Wed Oct 14, 2009 2:48 pm
Hi,
In autocad you can explode the contour, then it should have the same thickness than the other lines.
TopSolid2007
Master Chief
Posts: 133 Joined: Thu May 10, 2007 4:28 pm
Location: São Bernardo do Campo - SP
Contact:
Unread post
by TopSolid2007 » Tue Oct 20, 2009 3:31 pm
The best solution we found here was to firstly save the dft file as igs and open again this igs file and save as dxf/dwg...
The draw looks great this way, but the dimensions obviously were only texts.
TopSolid Users!!!!