Page 1 of 1

[Solved] Opening Solidworks Assemblies?

Posted: Wed Sep 26, 2007 9:02 pm
by Jonathan
Is there a way to open Solidworks Assembly files (xxx.SLDASM) in Top Solid? I can open most individual solid files but haven't been able to open any assemblies.

Posted: Wed Sep 26, 2007 9:29 pm
by Top'Noob
As far as I know you can not do this in TS.

My other software does have this ability so if you need help with a particular file, e-mail the .sldasm and everything that goes with it and I'll send you a parasolid. :wink:

Posted: Wed Sep 26, 2007 9:45 pm
by Jonathan
Thanks, I'll keep that in mind, this time I have all the individual files and assembled them one at a time. Sometimes I only get the .SLDASM files and then I can only look at them in the eDrawings viewer.

Posted: Fri Sep 28, 2007 8:55 am
by jalapeno
Hi,

normally it should be able, but you need the spatial translator. This interface is able to read Assemblies from Solid Works.
What can you do?
Ask your TopSolid Dealer for that Spatial Translator, please note you need a license to use this interface.
After installation you can choose between two interfaces for Solid Works.
Regards.

Posted: Fri Sep 28, 2007 3:55 pm
by TopSolid2007
I think Missler should supply it as default.... as many other softwares...