Page 1 of 1

Mirror parts

Posted: Wed Oct 14, 2015 10:59 am
by Erik Davidson
Hi,

Is there a way to mirror parts / components in a fast way? When you repeat parts in an assembly with mirror you en up with mirrored parts but I haven't found away to do this on a single part to quickly create a mirror of a part. I have tried edit / transform but to no luck. Anyone have any ideas?

Re: Mirror parts

Posted: Wed Oct 14, 2015 3:40 pm
by Mark Oostveen
What is you real problem? That you can't select a single shape in a multi shape component?

Re: Mirror parts

Posted: Wed Oct 14, 2015 5:40 pm
by Erik Davidson
Hi,

No. I would like to make a mirror of a whole assembly. This is possible when I mirror stuff in a repeat process with simple or double mirror but then the assemblies are connected to each other which complicates further work. I would like to be able to mirror a singe assembly and create a mirrored version of that assembly.

Re: Mirror parts

Posted: Wed Oct 14, 2015 5:53 pm
by Mark Oostveen
So just save as and than mirror. Or?......

You might try to use. Shape, transform, mirror
(Asuming you use TopSolid V6)

Re: Mirror parts

Posted: Wed Nov 18, 2015 8:30 pm
by Todd
you need to you duplicate--- then mirror and follow existing operations

Re: Mirror parts

Posted: Thu Nov 19, 2015 8:21 am
by remi77
Hello

In some cases, you can even create a mirror part (any transformation you want), then you create a new alternative set with your mirrored part only.

See you

RĂ©mi :wink: