Point dimensioning in paper space

Proposals and Suggestions for new features in TopSolid.

Moderators: remi77, Daniel, jacs

User avatar
Larry M.
Master Chief
Master Chief
Posts: 132
Joined: Thu Apr 12, 2007 3:03 am
Location: Michigan

Point dimensioning in paper space

Unread post by Larry M. » Sat Jun 30, 2007 4:22 am

When dimensioning in paper space, if you select point and select a circle it will snap to the center of the circle automatically, but if you select an arc it will not. So you have to go use snap point center every time. I design molds and get quite a few keyed ejector pins that never display as a full circle, only as a set of arcs. I'd like the software to snap to the center of an arc if I pick it , when I am not at an end point of the arc, when using point dimensioning. I just find the current way to be a repetitive pain in the bottom. Thanks.

This is using the Fast Dimensioning.

Post Reply