Page 1 of 1

Analyze Dynamic enhancement request

Posted: Thu Mar 08, 2007 5:39 pm
by Matt Berube
Hello, I have made a video of a feature which I feel would be a huge benefit to TopSolid users. Note that we can easily check the radius and angle of any face even if it has a varied radius or varied angle.

In my opinion this should enhance the analyze category of all TopSolid modules.

This link should take you to the video clip.

ugh... bad link... see below.

Thoughts ?

Posted: Thu Mar 08, 2007 8:45 pm
by reThinker
I think that would be an excellent addition to TopSolid. And is worth looking into. The current functions to check geometry do leave something to be desired.

Posted: Fri Jan 04, 2008 3:51 pm
by Matt Berube
I just had somebody point out that the above link was bad. :oops:

I will attach the file directly...

Watch in fullscreen mode for clearer picture.