Analyze Dynamic enhancement request

Proposals and Suggestions for new features in TopSolid.

Moderators: remi77, Daniel, jacs

User avatar
Matt Berube
Master Corporal
Master Corporal
Posts: 45
Joined: Wed Feb 21, 2007 7:08 pm
Location: Connecticut, USA

Analyze Dynamic enhancement request

Unread post by Matt Berube » Thu Mar 08, 2007 5:39 pm

Hello, I have made a video of a feature which I feel would be a huge benefit to TopSolid users. Note that we can easily check the radius and angle of any face even if it has a varied radius or varied angle.

In my opinion this should enhance the analyze category of all TopSolid modules.

This link should take you to the video clip.

ugh... bad link... see below.

Thoughts ?
Last edited by Matt Berube on Fri Jan 04, 2008 3:49 pm, edited 1 time in total.
TopSolid 2006, Design 6.7.302, Cam 6.7.302, Mold 6.7.302

Mastercam X2, Mill3, Wire, Solids, Moldplus, Beta Tester

User avatar
reThinker
Private
Private
Posts: 3
Joined: Fri Mar 02, 2007 4:08 pm
Location: Cincinnati, OH
Contact:

Unread post by reThinker » Thu Mar 08, 2007 8:45 pm

I think that would be an excellent addition to TopSolid. And is worth looking into. The current functions to check geometry do leave something to be desired.

User avatar
Matt Berube
Master Corporal
Master Corporal
Posts: 45
Joined: Wed Feb 21, 2007 7:08 pm
Location: Connecticut, USA

Unread post by Matt Berube » Fri Jan 04, 2008 3:51 pm

I just had somebody point out that the above link was bad. :oops:

I will attach the file directly...

Watch in fullscreen mode for clearer picture.
Attachments
clip0008.zip
(885.11 KiB) Downloaded 443 times
TopSolid 2006, Design 6.7.302, Cam 6.7.302, Mold 6.7.302

Mastercam X2, Mill3, Wire, Solids, Moldplus, Beta Tester

Post Reply