updating rough

[solidsnake]

I have big problems with the update of the material in your process
I have a core i7 16g ram windows 8 64-bit nvidia geforce 2g ram
I saw it in 3d workings update processing is impossible!!
it takes too much time ...
the processor works more than 30%
can speed up the update stock?
as a revolutionary software TopSolid 7 has a very big fault if you can not use the stock update!!
check in you see the result ... but not the same to use the updated stock!
also work with the disabled collision detection is a big problem ... the kinematics is slowed ...
any suggestions?!

[Bill]

HI there,

Did you try switching to the Faceted Stock update mode instead? On complex parts, this mode is significantly faster.