Page 1 of 1
Trochodial Milling
Posted: Tue Jul 03, 2012 4:51 pm
by cam
Is it possible to do trochodial milling in TS CAM V7.6 ??
And how does it work ?
Yes
Posted: Wed Aug 08, 2012 11:23 am
by YannDODIN
Yes you can do trochoidal milling. You can do it in grooving (you create a line and use the grooving operation then selct the trochoidal).
I have tried a few times and it is ok!
Posted: Fri Aug 10, 2012 3:49 pm
by cam
Thankyou, it works well...
[Solved] Re: Trochodial Milling
Posted: Mon Sep 03, 2012 1:05 pm
by remi77
cam wrote:Is it possible to do trochodial milling in TS CAM V7.6 ??
And how does it work ?
Posted: Wed Sep 26, 2012 5:50 pm
by Bill
You can do it in any tool path that is a roughing tool path. End milling, slot milling, roughing...