TopSolid'Forum

Hello everyone,

Now that I have a functional post processor I wanted to run some tests. I have a simple part programmed using the SUPER FINISH toolpath. I successfully created a program and ran it in the machine. Unfortunately the program is not producing G2 or G3 arc moves even though the part is round. I am getting many many tiny G1 linear moves. This is causing the machine to run very slowly because there are so many tiny lines of code in the program.

How can I make TopSolid 7 "filter" the toolpath and create a more efficient program using arcs instead of tiny linear segments?

Is there an option to set within TopSolid 7 or perhaps a change to be made in the post processor?

Hi,

What kind of 2D or 3D programs?

- If 2D, should do, if it does not, have to change the PP
- If 3D is in principle only makes the approaches / retracts to make the whole toolpath you must activate "Nurbs Optimization", in V6 in 7 should be the same principle.

Best Regards
Flávio Ruivo

Thanks for the reply flavio_ruivo

I didn't reply sooner because I never got e-mail notification that this thread was updated.

I looked for Nurbs Optimization but couldn't find anything like that

Hi,

Yes is true, not have this option yet, I hope that have in the future.

Best Regards,
Flávio Ruivo