Page 1 of 1
[Solved] Cant post process in TS7
Posted: Wed Nov 09, 2011 2:02 pm
by Top'Noob
Hello everyone,
How can I access the post processors in TS7?
I've been running thru tutorials and I want to test some NC code.
I believe I am looking in the correct place but there are no post processors available to select and everything is grayed out.
Posted: Wed Nov 09, 2011 3:37 pm
by Liam
Hi !
Are you running the software in demo mode ?
If yes, it's normal because you can't do any post-processing in demo mode.
Posted: Wed Nov 09, 2011 4:14 pm
by Top'Noob
No, I have a license. It expires soon but it's currently valid and my VAR is working on getting a new one for me.
Posted: Wed Nov 09, 2011 4:24 pm
by Top'Noob
The post files seem to be installed in my PC but I can't figure out how to use them
Posted: Wed Nov 09, 2011 4:32 pm
by Liam
I'm not an expert in v7, therefore unfortunately I can't help you more ...
May be someone else could answer or contact your Var about it.
Posted: Wed Nov 09, 2011 4:35 pm
by Top'Noob
OK, Thanks Liam! I am waiting for a reply from the VAR
Posted: Mon Nov 14, 2011 4:16 pm
by Top'Noob
It turned out that we can't post process with only a basic TopSolid 7 installation. We must contact the VAR and the VAR creates a stand-alone post processor installation for all post processors required by the user.