Everything about new TopSolid'Cam 7 software.
Moderators: remi77 , Daniel , Bill
Top'Noob
First Officer Cadet
Posts: 245 Joined: Fri Jun 15, 2007 3:05 pm
Unread post
by Top'Noob » Wed Nov 09, 2011 2:02 pm
Hello everyone,
How can I access the post processors in TS7?
I've been running thru tutorials and I want to test some NC code.
I believe I am looking in the correct place but there are no post processors available to select and everything is grayed out.
Attachments
Liam
Private
Posts: 8 Joined: Thu Feb 22, 2007 11:23 am
Location: Villeurbanne
Contact:
Unread post
by Liam » Wed Nov 09, 2011 3:37 pm
Hi !
Are you running the software in demo mode ?
If yes, it's normal because you can't do any post-processing in demo mode.
Top'Noob
First Officer Cadet
Posts: 245 Joined: Fri Jun 15, 2007 3:05 pm
Unread post
by Top'Noob » Wed Nov 09, 2011 4:14 pm
No, I have a license. It expires soon but it's currently valid and my VAR is working on getting a new one for me.
Attachments
Top'Noob
First Officer Cadet
Posts: 245 Joined: Fri Jun 15, 2007 3:05 pm
Unread post
by Top'Noob » Wed Nov 09, 2011 4:24 pm
The post files seem to be installed in my PC but I can't figure out how to use them
Attachments
Liam
Private
Posts: 8 Joined: Thu Feb 22, 2007 11:23 am
Location: Villeurbanne
Contact:
Unread post
by Liam » Wed Nov 09, 2011 4:32 pm
I'm not an expert in v7, therefore unfortunately I can't help you more ...
May be someone else could answer or contact your Var about it.
Top'Noob
First Officer Cadet
Posts: 245 Joined: Fri Jun 15, 2007 3:05 pm
Unread post
by Top'Noob » Wed Nov 09, 2011 4:35 pm
OK, Thanks Liam! I am waiting for a reply from the VAR
Top'Noob
First Officer Cadet
Posts: 245 Joined: Fri Jun 15, 2007 3:05 pm
Unread post
by Top'Noob » Mon Nov 14, 2011 4:16 pm
It turned out that we can't post process with only a basic TopSolid 7 installation. We must contact the VAR and the VAR creates a stand-alone post processor installation for all post processors required by the user.