cam7 work

Everything about new TopSolid'Cam 7 software.

Moderators: remi77, Daniel, Bill

solidsnake
Master Corporal
Master Corporal
Posts: 43
Joined: Thu Oct 21, 2010 3:22 pm

cam7 work

Unread post by solidsnake »

Image

I tried to upload an image to explain how to perform a processing ...
an internal groove radius with a disc cutter ...
but no matter the size of the operation ...
side mill? or other operation?
with or without profiles? using only the faces?
thanks
Last edited by solidsnake on Fri Jun 03, 2011 5:46 pm, edited 1 time in total.
solidsnake
Master Corporal
Master Corporal
Posts: 43
Joined: Thu Oct 21, 2010 3:22 pm

cam 7

Unread post by solidsnake »

Image

I tried to run the 3D contour machining ....
without profiles and surfaces without ...
using only the faces ...
in the processing of 3D contouring is not possible to extend the path ...
to avoid collision in and out ....?
Last edited by solidsnake on Fri Jun 03, 2011 5:46 pm, edited 1 time in total.
User avatar
remi77
Administator
Administator
Posts: 348
Joined: Thu Feb 22, 2007 10:05 am
Contact:

Unread post by remi77 »

Hi,

You may check your link to the pictures :wink:

See you,

Rémi :wink:
solidsnake
Master Corporal
Master Corporal
Posts: 43
Joined: Thu Oct 21, 2010 3:22 pm

work

Unread post by solidsnake »

Image


I'm looking for someone who can explain how to work the piece in the picture ...
I do a throat with a disc cutter ... but with the side mill ...
The tool works on the outside ... and do not enter inside the pits ...
Why?
I hope to make me understand ..
thanks
Post Reply