Machining Methods - Select entities by name
Posted: Fri Aug 28, 2020 12:30 am
Methods - Select entities by name
I have created some methods and it is working fine but I would like to improve it.
I would like to allow to automatically select entities by name.
I have already made some test without success.
I my methods selection of part faces and (in another point) selection on curves works fine.
Entities I want to select (by name) are available as publications, auxiliar entities or representations.
My question is: where or how in interface I specify entities names and what names I should supply?
Thank you.
I have created some methods and it is working fine but I would like to improve it.
I would like to allow to automatically select entities by name.
I have already made some test without success.
I my methods selection of part faces and (in another point) selection on curves works fine.
Entities I want to select (by name) are available as publications, auxiliar entities or representations.
My question is: where or how in interface I specify entities names and what names I should supply?
Thank you.