Page 1 of 1

Milling in the center axis

Posted: Fri Jul 13, 2018 10:15 pm
by SnakeCZCOM
Hello
I apologize in advance for my English.
I have a problem in milling the excentric grooves on the circumference of the cylinder. When milling I need the cutter to be in the center of the piece axis (Y = 0). However, when generating a trajectory, the tool goes out of the axis (Y = 5 and Y = -5). I have disabled the OffCenter feature.
Can it be that, the groove is eccentric? Is it possible to adjust the tool to the center of the axis?
Thank you

Re: Milling in the center axis

Posted: Fri Jul 13, 2018 10:16 pm
by SnakeCZCOM
...