Forum about TopSolid'Design 7 release.
Moderators: remi77 , jacs , Daniel , Bill , Romain
cam
Master Corporal
Posts: 39 Joined: Fri Oct 02, 2009 9:46 am
TopSolid Module: TopSolid'Cam
TopSolid Version: 7.8
Location: Germany
Unread post
by cam » Fri Feb 21, 2014 4:45 pm
Hi,
is there a list available with commandline parameters for TS7 design ?
Last edited by
cam on Fri Jun 24, 2016 2:08 pm, edited 2 times in total.
JuP
Major
Posts: 169 Joined: Tue Sep 09, 2014 5:45 pm
Answers: 6
TopSolid Module: TopSolid'Steel
TopSolid Version: 7.14
Unread post
by JuP » Tue Sep 23, 2014 10:23 am
Hello,
F1 key -> Search Tab -> write "floor" and open "Entering a value"
cam
Master Corporal
Posts: 39 Joined: Fri Oct 02, 2009 9:46 am
TopSolid Module: TopSolid'Cam
TopSolid Version: 7.8
Location: Germany
Unread post
by cam » Wed Sep 24, 2014 5:12 pm
Hello Julien,
thankyou, but this is not what I mean.
I have now found.
Start a terminal an type "Path where TopSolid.exe is" with parameter /? and you will get a list with available command line parameters.
JuP
Major
Posts: 169 Joined: Tue Sep 09, 2014 5:45 pm
Answers: 6
TopSolid Module: TopSolid'Steel
TopSolid Version: 7.14
Unread post
by JuP » Thu Sep 25, 2014 7:19 am
oh, I understand,
An other:
-p "new pdm directory"
If there is not PDM at this adress, TopSolid created a new