Part count

Forum about TopSolid'Design 7 release.

Moderators: remi77, Daniel, jacs, Romain, Bill

liumenite
Private
Private
Posts: 2
Joined: Fri Jul 15, 2011 9:41 pm

Part count

Unread post by liumenite » Tue Aug 30, 2011 12:18 am

I was wondering if there was a way to use the part count as a parameter.
I can see it as a integer parameter under parameters, but is there a way to reference it into other parameters? I've tried publishing it to no success.

Also I was wondering if there was a way in Top Solid to count different parts, so that it could also be referenced as a parameter, like creating a ratio or percentage in terms of different types of parts.

thanks!

Post Reply