Page 1 of 1

TS7 drafting help

Posted: Fri Nov 13, 2009 4:28 pm
by Top'Noob
Hello,

I have a TS7 assembly document with some cavity blocks and an electrode. How can I create a draft document with some specific entities from the assembly ? I want my draft to include the lower cavity block and the blue electrode. I can't figure out how to choose which entities are shown in the draft. So far it seems I can have all or nothing.

Any help would be appreciated. Thanks.

Posted: Mon Nov 16, 2009 12:40 pm
by olaio
Hi TopNoob,

I think that you have to create a new "repesentation" with the parts that you want to project.

Posted: Thu Nov 19, 2009 2:53 pm
by Top'Noob
Thanks Olaio !

I still do not have a clear understanding of the whole situation but I was able to get better results using your advice.

I'll have to keep playing with this as time permits. After I get just a little better I'll be using the new version for all of my electrodes and the associated documentation.

draft

Posted: Tue Nov 24, 2009 10:35 pm
by mj
Hello

YOU CAN DRAG AND DROP SPECIFIC ITEMS INTO A DRAFT DOC FROM THE ASSEMBLY TREE OF THE MODEL ASSEMBLY.

I HOPE THIS HELPS