Page 1 of 1
Are Part > Properties disabled for the trial version?
Posted: Thu Jul 06, 2017 6:23 pm
by michelle
Hello,
I went to edit the Properties of a PART which I just created and all fields are greyed out (see screenshot).
Additionally Tools > Material & Coating fields are also blanked out.
Is this functionality disabled for the trial version of TS?
Not to worry, I see I can edit these values via Entities Dialog > Parameters > System Parameters
ooooo.... you have to select EDIT on the bottom of the Properties window (shown in screenshot above).
Thanks,
Michelle
Re: Are Part > Properties disabled for the trial version?
Posted: Thu Jul 13, 2017 6:48 pm
by JuP
Hi Michelle,
It's cool you are very fast to answer your questions!
I think in one week we are ready to make a TopSolid FAQ with your topics
Have a nice day !
Re: Are Part > Properties disabled for the trial version?
Posted: Thu Jul 13, 2017 9:12 pm
by michelle
Haha
This seems to be a very quiet forum - I'm beginning to think I must be the only one with TopSolid questions!!
Re: Are Part > Properties disabled for the trial version?
Posted: Sat Jul 15, 2017 1:21 am
by Brian
Hi Michelle:
The French forum (
http://forum.TopSolid.fr) has much more activity, and might be helpful....if you can read French!
Cheers, Brian
Re: Are Part > Properties disabled for the trial version?
Posted: Mon Jul 17, 2017 5:32 am
by JuP
Before I came to this forum every day but there was no more new topic about TopSolid 7... I hope that will change
Re: Are Part > Properties disabled for the trial version?
Posted: Mon Jul 17, 2017 9:15 am
by michelle
Oh I plan to ask LOTS of questions so if you are up for answering them Julian we can make it a very busy forum! haha.
Brian - thanks very much for the note you sent me - very useful! - I tried to reply to you but I think your inbox is too full to accept new messages.
Re: Are Part > Properties disabled for the trial version?
Posted: Tue Sep 05, 2017 2:47 am
by Brian
Hi Michelle:
I just sent you a reply to your PM-sorry for the late response. I think I may have hosed up something with my PM settings-not sure. I will assume "operator error" for now-LOL!
Cheers, Brian