Strange limit on Force values in Table parameter

Forum about TopSolid'Design 7 release.

Moderators: remi77, Daniel, jacs, Romain, Bill

d.k.liu
Private First Class
Private First Class
Posts: 13
Joined: Mon Nov 24, 2014 1:06 pm
TopSolid Module: TopSolid'Design
TopSolid Version: 7.5

Strange limit on Force values in Table parameter

Unread post by d.k.liu » Fri Jan 15, 2016 4:14 am

I'm trying to create Table parameter with Force output values. TopSolid wouldn't let me put in output values greater than 1kN! A normal real parameter can take on values > 1kN. But if I try to get the table to refer to an existing real parameter with value>1kN it will still complain and fail.

Anyways to remove this highly restrictive limit?

Post Reply