Use letters for drilling table Indexes
Posted: Wed Dec 24, 2014 2:34 pm
I want to have a table of holes and tapped holes and dowel holes... The dowel holes need to show as 4 place decimal.. I have not been able to figure out how to do this in one Drilling table
So I thought I would create a separate Dowel drilling table, but the numbering starts at 1 again for the second table.... Is there a way to change to letter indexes ???
So I thought I would create a separate Dowel drilling table, but the numbering starts at 1 again for the second table.... Is there a way to change to letter indexes ???