Use letters for drilling table Indexes

Forum about TopSolid'Design 7 release.

Moderators: remi77, Daniel, jacs, Romain, Bill

eric14779
Master Corporal
Master Corporal
Posts: 32
Joined: Wed May 05, 2010 1:24 am
TopSolid Module: TopSolid'Design
TopSolid Version: 7.6
Location: Upstate New York (Buffalo)

Use letters for drilling table Indexes

Unread post by eric14779 » Wed Dec 24, 2014 2:34 pm

I want to have a table of holes and tapped holes and dowel holes... The dowel holes need to show as 4 place decimal.. I have not been able to figure out how to do this in one Drilling table
So I thought I would create a separate Dowel drilling table, but the numbering starts at 1 again for the second table.... Is there a way to change to letter indexes ???

User avatar
JuP
Master Chief
Master Chief
Posts: 127
Joined: Tue Sep 09, 2014 5:45 pm
TopSolid Module: TopSolid'Design
TopSolid Version: 7.14

Re: Use letters for drilling table Indexes

Unread post by JuP » Mon Sep 07, 2015 2:17 pm

Hello,

You have to use styles (entities tree) to change the number of decimals, if you are creating the drilling table:
2015-09-07_14-13-17.png
If the table is already created create a new style and apply it (right click and Apply):
2015-09-07_14-14-35.png
Julien . P
Youtube
Grabcad

eric14779
Master Corporal
Master Corporal
Posts: 32
Joined: Wed May 05, 2010 1:24 am
TopSolid Module: TopSolid'Design
TopSolid Version: 7.6
Location: Upstate New York (Buffalo)

Re: Use letters for drilling table Indexes

Unread post by eric14779 » Wed Sep 16, 2015 6:45 pm

JuP,

Thanks for the reply, but what you describe is not what I am talking about.

I am talking about having letters instead of numbers for the indexes for a hole table...

Post Reply