Hello,
i have some dificulties with extruding on lateral surface of a cylinder:
I am able to roll up a 2D-sketch onto a cylindrical surface but problems start as soon as i want to pocket extrude the wound up profile as it is a 3D-sketch.
A normal extrsuion followed by a boolean subraction would be possible, but i cannot match the the axis of extrusion to the perpendicular axis of the envelope. Even i i managed to do so then the result would not be accurate, as there has to be a taper on all surfaces of the extrusion that are - also just partially - in line with the cylinder axis.
When i try to shape the envelope-cutout with the perpendicular-surface-opration onto the lateral surface of the cylinder i get an error.
Can anyone help please
Extruding on envelope surface of a cylindeer
Moderators: remi77, jacs, Daniel, Bill, Romain
-
- Private
- Posts: 6
- Joined: Wed Feb 10, 2021 9:02 am
- TopSolid Module: TopSolid'Design
- TopSolid Version: 7.11
-
- Private First Class
- Posts: 14
- Joined: Thu Oct 19, 2017 2:07 pm
- TopSolid Module: TopSolid'Cam
- TopSolid Version: 7.4
Re: Extruding on envelope surface of a cylindeer
Hello Alexander,
I believe you need to create an 3D Sketch using "Other operations" > "Rolling up Wizard " to wrap contour around your surface.
After that you will need (I think) to create a new surface normal to a surface of your product.
Beware of eventual error messages.
In version 7.15 there was an error that should be fixed but I did not try again yet.
Anyway, it is possible to walk around this error "seeding" or smoothing you wrapped curve to a larger number of points. This in 7.15.
In version 7.14 I have done without any errors.
For a center milling or slot machining I think it is going to be enough.
When designing a driving slot, I use a perpendicular surface which I thicken and subtract from main solid.
I hope this helps. Best regards.
I believe you need to create an 3D Sketch using "Other operations" > "Rolling up Wizard " to wrap contour around your surface.
After that you will need (I think) to create a new surface normal to a surface of your product.
Beware of eventual error messages.
In version 7.15 there was an error that should be fixed but I did not try again yet.
Anyway, it is possible to walk around this error "seeding" or smoothing you wrapped curve to a larger number of points. This in 7.15.
In version 7.14 I have done without any errors.
For a center milling or slot machining I think it is going to be enough.
When designing a driving slot, I use a perpendicular surface which I thicken and subtract from main solid.
I hope this helps. Best regards.