Introduction
Posted: Fri Jan 04, 2008 2:22 am
Hello TS Users:
I have been a moldmaker for 26 years and designing molds for 8 yrs. using a basic solid modeling software. I have been researching mold design software for four months. I am excited about TS mold design software it seems to have all the features that I have been looking for and wished I had over the years. I am looking forward to getting started with this new software. I manage a small shop we design build & repair plastic injection molds. I enjoy watching my girls in their various activiites and when time allows I enjoy flying R/C helicopters. Again I look forward to my furture with TS.
Location Indiana, USA
Mark
I have been a moldmaker for 26 years and designing molds for 8 yrs. using a basic solid modeling software. I have been researching mold design software for four months. I am excited about TS mold design software it seems to have all the features that I have been looking for and wished I had over the years. I am looking forward to getting started with this new software. I manage a small shop we design build & repair plastic injection molds. I enjoy watching my girls in their various activiites and when time allows I enjoy flying R/C helicopters. Again I look forward to my furture with TS.
Location Indiana, USA
Mark
