TopSolid'Forum

Hi@all,

I want to change the config. paths in TS, so every user of the software shall use the same

top.mat (for material)
Top.cgi (for user -informations)
*.bom (for part lists)

Does anybody know where I can change this paths?

greetings from germany

frankm

Hi,

the good idea is to insert in the group folder what you want to share between your users.

To define correctly the group location, you may have to go in the add/remove program list, select TopSolid, and modify your group path to set it correctly to allow its sharing.

Do it on each PC, set the same group place, and it would be good

Jehronimo

be careful with the top.mat file. if you have imported textures other than the ones provided with TopSolid this could create some problems.