Page 1 of 1
✅ How to create serial copy of parts
Posted: Wed Jun 10, 2020 9:46 am
by PrafulGaikwad
Hello,
We have a situation where we want to create number of parts in curvature distribution. (as attached image)
I have found a similar video on youtube showing the same design but did not understand.
https://youtu.be/FWskGKAi-wk?t=26
Can anybody suggest how to create this type of design easily.
Thanks & Regards,
Praful
Re: How to create serial copy of parts
Posted: Wed Jun 10, 2020 10:26 am
by RaudMees
Hello
Read this document: TopSolid.TT.Wood.Serial.Copy.v6.17. Ask it from reseller.
RM
Re: How to create serial copy of parts
Posted: Wed Jun 10, 2020 12:49 pm
by PrafulGaikwad
Thanks for your reply.
Can you please tell me which topic is that, I have read it but nothing found related.
Thanks,
Praful
Re: How to create serial copy of parts
Posted: Wed Jun 10, 2020 1:36 pm
by Todd
]When you make the component you will need to create driving points that are not constrained and those points will be used to follow each guide curve that will be divided equally based on how many panels you need
Re: How to create serial copy of parts
Posted: Tue Jun 16, 2020 2:16 pm
by OMG
Hello
I can send you these via e-mail
MG
Re: How to create serial copy of parts
Posted: Tue Sep 29, 2020 4:45 am
by Jason_Scott
OMG if you could email them to me also I would appreciate it greatly.
jason_cabinetmaker@yahoo.com
Thanks in advance.
Re: How to create serial copy of parts
Posted: Wed Sep 30, 2020 7:29 am
by OMG
solved
I've sent you the e-mail
Re: How to create serial copy of parts
Posted: Wed Sep 30, 2020 7:49 am
by remi77
Hi
Solved ?
In that case, you may add the green check on your first message
See you
Rémi
Re: How to create serial copy of parts
Posted: Wed Sep 30, 2020 9:18 am
by OMG
"solved" means I've sent him the e-mail
is not my post to edit it as "solved"
Re: How to create serial copy of parts
Posted: Sat Sep 03, 2022 8:06 am
by remi77
Hi
Of course it's not
Rémi