Hello
Is there a way to configure TSW to display in Alpha bar not only the simple distance between two 3D points but the X, Y and Z components too (the ones you see in 3D area)?
Thank you
TSW "Distance" command output
Moderators: remi77, jacs, Daniel
Re: TSW "Distance" command output
Hello,
you need to have at least two lines on your alpha bar:
Best regards
you need to have at least two lines on your alpha bar:
Best regards
- OMG
- Master Chief
- Posts: 113
- Joined: Sun Nov 11, 2018 7:26 pm
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.20
Re: TSW "Distance" command output
Hello
My alpha bar is always detached and shown because I use two monitors.
I still don't manage to obtain the measurement as you did.
I tried to switch between "value" and "element" in "status bar configuration / measurement" but without any luck
My alpha bar is always detached and shown because I use two monitors.
I still don't manage to obtain the measurement as you did.
I tried to switch between "value" and "element" in "status bar configuration / measurement" but without any luck
-
- Second Officer Cadet
- Posts: 209
- Joined: Wed Dec 30, 2015 11:25 am
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.20
- Contact:
Re: TSW "Distance" command output
Maybe You have to change some settings.
I have this.
I have this.
- Attachments
-
- dist.png (5.02 KiB) Viewed 1653 times
- Laurens
- Sergeant
- Posts: 51
- Joined: Tue Apr 16, 2019 7:29 am
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.24
Re: TSW "Distance" command output
i get both results RaudMees. if i measure from point to point i get what you have. if i choose plane->point then i get what OMG has. so far i have yet to find a setting for this
Laurens
Team leader TSW draftsmen
De Klerk Binnenbouw
Team leader TSW draftsmen
De Klerk Binnenbouw