Edgebanding Over-evaluation/Over-dimension
Posted: Mon Jan 27, 2020 8:46 pm
Hello All,
Got a bit of a puzzle I need help with, regarding the Panel function in TopSolid'Wood.
We use two thicknesses of edgeband - 0.5mm and 3mm.
When the panel function is applied, it removes 0.5mm or 3mm from the panel edges to compensate for the thickness of the edgeband.
However, our edgebander removes 0.5mm when it prepares the panel edge. So, ideally, we want it to take 0mm off when 0.5mm edging is applied, and 2.5mm when 3mm edging is applied.
I've mucked around with the "Over Dimension" and "Calibration overvaluation" settings in Tools>Options>TopSolid'Wood Configuration>Edge/Laminate to no avail.
Any ideas on how to correct this?
Thanks!
Got a bit of a puzzle I need help with, regarding the Panel function in TopSolid'Wood.
We use two thicknesses of edgeband - 0.5mm and 3mm.
When the panel function is applied, it removes 0.5mm or 3mm from the panel edges to compensate for the thickness of the edgeband.
However, our edgebander removes 0.5mm when it prepares the panel edge. So, ideally, we want it to take 0mm off when 0.5mm edging is applied, and 2.5mm when 3mm edging is applied.
I've mucked around with the "Over Dimension" and "Calibration overvaluation" settings in Tools>Options>TopSolid'Wood Configuration>Edge/Laminate to no avail.
Any ideas on how to correct this?
Thanks!