TopSolid'Forum

hello i have a problem with topsolidwood 6.20

when i add a components that have diactiveited parts i see the parts that diactiveited
only when i push on regenereited the parts not seeing

Hi

It's a bit hard to understand where is the problem. When you deactivate element, then they are visible in same document, but they are not visible in project. In both cases they are not shown in BOM. I don't know what You are doing there, but don't deactivate components - use repeat function to turn them on/off.

RM

hello RaudMees tank for youre anser
but this is the problem that the deactivated element is visible in project.
i have two conections set in one component that i activat one conection set
and deactivated the other
and when i put component in the project i see them both
until i make regenereited then the deactivated parts are invisible

I prefer do not use deactivate command to switch off elements inside of components. You can use that in project before creating 2D drawings and BOM. To turn off elements, use repeat function.

RM

hello RaudMees and tanks agen for youre answer
it is a good idea to use reapit function
but i have a lot off component that i already
create with active disactive
in version 6.19 there is now problem with that
it is a bug that have in 6.20
i need a support for that bug
tank you Jenia nastaskin

Can you show your attributes settings of these components

attributes settings of these components

watt do you mean wher i can see my attributes settings of components?

i do as you show in the photos
and it is the same as befor
the diactiveited parts are showing in assembly

You have to do it before placing a component! Nou you have to activate them again and then deactivate to see it working after a regenerate

it is work!!!
tank you very much

jwdesign wrote: ↑Thu Oct 17, 2019 7:26 pm it is work!!!
tank you very much

You're welcome, glad to be of assistance