Page 1 of 1
How to show codification edge for multi daft nesting label
Posted: Fri Mar 22, 2019 9:16 am
by sinvia
Dear All friends,
I would like to show codification edge when Multi draft nesting label as bellows:
https://imgur.com/Ammi0zd
Can I do this. Please help me.
Sinvia
Re: How to show codification edge for multi daft nesting label
Posted: Fri Mar 22, 2019 10:09 am
by RaudMees
It's described in TopSolid Wood Advanced v 6.16 book on page 118. Place the axes automatically.
RM
Re: How to show codification edge for multi daft nesting label
Posted: Fri Mar 22, 2019 3:44 pm
by sinvia
Dear RM,
I would like to show the edge of panel when do "Multi draft Nesting lables" same as multi draft
https://ibb.co/3W2ZwzX
I try many times but I can not.
Please show me in detail,
Thank you,
Re: How to show codification edge for multi daft nesting label
Posted: Fri Mar 22, 2019 3:55 pm
by RaudMees
Hello
Do You have them in multi-draft mode?
And nesting labeling doesn't work?
RM
Re: How to show codification edge for multi daft nesting label
Posted: Sat Mar 23, 2019 3:04 am
by sinvia
Dear RM,
The codification edge is shown in multi draft. But No in Multi-draft nesting labels.
Nesting labels still works,
Can you show me your multi draft nesting labels with showing codification edge?
Sinvia.
Re: How to show codification edge for multi daft nesting label
Posted: Fri Jul 19, 2019 2:20 pm
by Allan B.
Hi Sinvia,
create a title block in your entire label and create 4 fields (one at left, right, top and bottom) then insert a BOM information in these fields.
Note: is it necessary to create a BOM with edges information. <WOO_ONE_EDGE_1>, <WOO_ONE_EDGE_2>, etc..
This will work, but your part definition must be the same in all your parts. Red arrow to Y- when using panel entities or edge function.
Enjoy