Page 1 of 1

Jagged edges in design environment

Posted: Sat Sep 08, 2018 5:20 am
by Robert
Is there any way to improve the graphics in the design environment to remove jagged edges so that the lines are smoother and straighter?

Thank you.

Re: Jagged edges in design environment

Posted: Sat Sep 08, 2018 7:38 pm
by Robert
attached is an example of the jagged edges.

Re: Jagged edges in design environment

Posted: Mon Sep 10, 2018 1:50 pm
by Todd
tolerance on your status bar.

Re: Jagged edges in design environment

Posted: Mon Sep 10, 2018 3:25 pm
by olaio
i am not sure if playing with the graphical tolerances is the best way...
This will take a big impact in TopSolid performance.
If possible i prefer to "play" with the graphic card options, for example use a bigger value for the antialiasing mode.
But maybe i am wrong...

Re: Jagged edges in design environment

Posted: Mon Sep 10, 2018 4:32 pm
by Todd
The tolerance is file specific unless your add these settings to your group config file