Is there a setting in draft that will thicken the outside edge of a assembly so that it shows up better through all the clutter of the dimension lines?
Thank you
Outline setting in draft
Moderators: remi77, jacs, Daniel
- Todd
- First Officer Cadet
- Posts: 246
- Joined: Mon Nov 10, 2014 9:28 pm
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.24
- Location: Detroit, MI
Re: Outline setting in draft
the easy way I found is in your print configuration set the color blue to print lighter than the black by make it light grey. so all your dim lines are thinner than the outline
-
- Second Officer Cadet
- Posts: 209
- Joined: Wed Dec 30, 2015 11:25 am
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.20
- Contact:
Re: Outline setting in draft
If You are done with those printer settings in printer config file, then make a backup of this for future. Sometimes update can overwrite it.
RM
RM