Driver (block) ?

CAD_73 · Unread post by **CAD_73** » Tue Sep 15, 2015 8:50 pm

I want to create some kind of a driver block like this.
I want it only to drive on the x-axis.

Any idea's.

Todd · Unread post by **Todd** » Tue Sep 15, 2015 9:02 pm

I would think you would want to make 2 extruded components first then put them together in a driver block as an assembly. just my advice I have a component just like this

CAD_73 · Unread post by **CAD_73** » Wed Sep 16, 2015 7:56 pm

Thanks Todd,

I'm going to try it somewhere next week, if I have time after hours.
At home I'm running "Demonstration Mode" so not able to save the file.

Todd · Unread post by **Todd** » Wed Sep 16, 2015 8:19 pm

Looking at this again you may only have to make 1 extruded component and insert it twice if its the same part twice

Todd · Unread post by **Todd** » Wed Sep 16, 2015 8:29 pm

here a screen shot of the tree

Mark Oostveen · Thu Sep 17, 2015 8:44 am

Just for information.

It is possible in V6. 16 to make a multi part extruded component. So may be that can be a solution to.

Regards

Mark

Todd · Unread post by **Todd** » Thu Sep 17, 2015 2:11 pm

yeah for sure I have not tried that new feature yet

CAD_73 · Unread post by **CAD_73** » Tue Oct 27, 2015 7:21 pm

Got it

Todd · Unread post by **Todd** » Tue Oct 27, 2015 7:27 pm

Nice good Job!

Mark Oostveen · Wed Oct 28, 2015 6:58 am

Mooi [emoji2]

TopSolid'Forum

Driver (block) ?

Driver (block) ?

Re: Driver (block) ?

Re: Driver (block) ?

Re: Driver (block) ?

Re: Driver (block) ?

Re: Driver (block) ?

Re: Driver (block) ?

Re: Driver (block) ?

Re: Driver (block) ?

Re: Driver (block) ?