Operation Manager and posting with 64 bit TopSolid 2007
Posted: Wed May 09, 2012 12:20 am
Hello in a previous post, it was said that adding a line to post-processing iso, ini file,(#Ok_For_Operation_List_At_Start = YES) you may choose to post-processing operations, but I have the following problem, as I have TopSolid 2007, to improve performance in machining pass to 64bits, and the postprocessing operations powderalarms that does not discriminate and post-processing entire file.
It is very harmful if I take as an option on and off operations and save the file to postprocess TopSolid from outside, if a, b, c reason, I forget to record or off a serious error can occur in the machining center.
I could give a better option this last please. It is supposed that he could choose to prosecute iso operations.
attached pictures of what ocurreo.
Greetings ...
It is very harmful if I take as an option on and off operations and save the file to postprocess TopSolid from outside, if a, b, c reason, I forget to record or off a serious error can occur in the machining center.
I could give a better option this last please. It is supposed that he could choose to prosecute iso operations.
attached pictures of what ocurreo.
Greetings ...